ISO 899-2:2024
Plastics — Determination of creep behaviour — Part 2: Flexural creep by three-point loading
This document specifies a method for determining the flexural creep of plastics in the form of standard test specimens under specified conditions such as those of pre-treatment, temperature and humidity. It is only applicable to a simple freely supported beam loaded at mid-span (three-point-loading test).
The method is suitable for use with rigid and semi-rigid non-reinforced, filled and fibre-reinforced plastics materials (see ISO 472 for definitions) test specimens moulded directly or machined from sheets or moulded articles.
NOTE The method can be unsuitable for certain fibre-reinforced materials due to differences in fibre orientation
The method is intended to provide data for engineering-design, quality control, research and development purposes.
The method might not be applicable for determining the flexural creep of rigid cellular plastics (attention is drawn in this respect to ISO 1209-1 and ISO 1209-2).
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$179.13 NZD
|
|
| HardCopy |
$214.78 NZD
|
|
| Networkable PDF |
Price varies
|
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
BS 2782-0:2011
Methods of testing plastic, Introduction
-
BS 2782-1:Method 140A:1992
Methods of testing plastics. Thermal properties, Determination of the burning behaviour of horizontal and vertical specimens in contact with a small-flame ignition source
-
BS 2782-1:Method 140E:1982
Methods of testing plastics. Thermal properties, Flammability of a small, inclined test piece exposed to an alcohol flame (laboratory method)
-
BS 2782-1:Method 150D:1976
Methods of testing plastics. Thermal properties, Cold crack temperature of film and thin sheeting