ISO 3547-6:2020
Plain bearings — Wrapped bushes — Part 6: Checking the inside diameter
The document specifies, following ISO 12301, the checking of the inside diameter of wrapped bushes (see ISO 3547‑2:2017, method C) and describes the necessary checking methods and measuring equipment.
NOTE 1 All dimensions in this document are given in millimetres except where otherwise noted/designated.
NOTE 2 The dimensions and tolerances of wrapped bushes are given in ISO 3547‑1.
NOTE 3 Checking of the wall thickness is the subject of ISO 3547‑7.
NOTE 4 Checking of the outside diameter of wrapped bushes is the subject of ISO 3547‑5.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$83.00 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Method of checking
6 Test equipment
6.1 Ring gauge
6.2 Plug gauge
6.3 Three-point measuring instrument
6.4 Requirements for measuring equipment
6.5 Measuring errors
7 Procedure
Bibliography
Previous versions
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
BS 4480-1:1992
Plain bearings: metric series, Sintered bushes. Dimensions and tolerances
-
BS 4480-2:1974
Specification for plain bearings: metric series, Solid plastics bushes
-
BS 4480-6:1984
Plain bearings: metric series, Specification for dimensions and tolerances of ring type thrust washers made from strip
-
BS 4480-8:1984
Plain bearings: metric series, Specification for dimensions, tolerances and methods of checking of thin-walled flanged half bearings
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Method of checking
6 Test equipment
6.1 Ring gauge
6.2 Plug gauge
6.3 Three-point measuring instrument
6.4 Requirements for measuring equipment
6.5 Measuring errors
7 Procedure
Bibliography