ISO 20267:2017
Thermal spraying — Determination of interfacial toughness of ceramic coatings by indentation
ISO 20267:2017 specifies a method for measuring the interfacial toughness of thermal spray ceramic coatings at room temperature based on an indentation method. The interfacial toughness is calculated from the mean length of cracks emanating from the corners of the impression induced by a Vickers hardness tester, and it is intended for use with ceramic coatings with a single layer or multilayers. The test procedures proposed in this document are intended for use in an ambient environment.
ISO 20267:2017 is recommended for thermal spray ceramic coatings such as thermal barrier coatings, wear resistant coatings and electrical insulating coatings.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$126.00 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Principle
6 Test pieces and sample preparation
6.1 Thicknesses of coating and substrate
6.2 Sample size
6.3 Sample cutting
6.4 Mounting
6.5 Surface polishing
7 Apparatus
8 Procedure and conditions of testing
8.1 Indentation
8.2 Indentation and crack length measurement
9 Evaluation of indentation interfacial toughness
9.1 Analysis
9.2 Test validity
10 Test report
10.1 Items to be reported
10.2 Other items to be reported
Bibliography
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
BS 4479-9:1990
Design of articles that are to be coated, Recommendations for low pressure and vacuum deposited coatings
-
BS 4495:1969
Recommendations for the flame spraying of ceramic and cermet coatings
-
BS EN 10298:2005
Steel tubes and fittings for onshore and offshore pipelines. Internal lining with cement mortar
-
BS EN 13144:2018
Metallic and other inorganic coatings. Method for quantitative measurement of adhesion by tensile test
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Principle
6 Test pieces and sample preparation
6.1 Thicknesses of coating and substrate
6.2 Sample size
6.3 Sample cutting
6.4 Mounting
6.5 Surface polishing
7 Apparatus
8 Procedure and conditions of testing
8.1 Indentation
8.2 Indentation and crack length measurement
9 Evaluation of indentation interfacial toughness
9.1 Analysis
9.2 Test validity
10 Test report
10.1 Items to be reported
10.2 Other items to be reported
Bibliography