ISO 15637-1:2002
Holding fixtures of cylindrical abrasive sleeves — Part 1: Holding fixtures with shank for hand-held grinding machines
ISO 15637-1:2002 applies to holding fixtures with shank for use with cylindrical abrasive sleeves with a diameter equal to or less than 100 mm in accordance with ISO 2421. Holding fixtures with shank having a diameter equal to or less than 100 mm mostly have lamellar cores and are used on hand-held grinding machines. The impact of centrifugal forces on the lamellae result in an increase in diameter and thereby clamp the abrasive sleeve on to the holding fixture.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$93.38 NZD
|
|
TitlePage - Holding fixtures of cylindrical abrasive sleeves—
Foreword - Foreword
Scope - 1 Scope
NormativeReference - 2 Normative reference
Clause1 - 3 Design and dimensions
Subclause2 - 3.1 Design
Subclause2 - 3.2 Dimensions
Clause1 - 4 Requirements
Subclause2 - 4.1 Holding fixtures
Subclause2 - 4.2 Shank
Clause1 - 5 Designation
Clause1 - 6 Marking
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
AS/NZS 4521:1997
Abrasive grains - Test-sieving machines
-
AS/NZS 4523:1998
Bonded abrasive products - General - Designation, marking, range of outside diameters and tolerances
-
AS/NZS 4524.1:1998
Bonded abrasive products - Dimensions - Part 1: Grinding wheels for external cylindrical grinding between centres
-
AS/NZS 4524.10:1998
Bonded abrasive products - Dimensions - Part 10: Honing stones and superfinishings
TitlePage - Holding fixtures of cylindrical abrasive sleeves—
Foreword - Foreword
Scope - 1 Scope
NormativeReference - 2 Normative reference
Clause1 - 3 Design and dimensions
Subclause2 - 3.1 Design
Subclause2 - 3.2 Dimensions
Clause1 - 4 Requirements
Subclause2 - 4.1 Holding fixtures
Subclause2 - 4.2 Shank
Clause1 - 5 Designation
Clause1 - 6 Marking