BS 2564:1955
Date published:
Control chart technique when manufacturing to a specification, with special reference to articles machined to dimensional tolerances
By B. P. Dudding and W. J. Jennett. Practical guidance on use of Quality Control; describes procedures found acceptable when introducing and operating Control Chart technique as factory routine. Utilization of results of measurement (quantitative data); utilization of results of classifying product into categories (qualitative data). Directions for construction and interpretation of Control Charts for various classes of process, and routine to be used. Examples.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$532.48 NZD
|
|
| HardCopy |
$523.48 NZD
|
|
Related Information
03.120.30 Application of statistical methods
Similar Standards
-
AS/NZS IEC 60706.5:2022
Maintainability of equipment, Part 5: Testability and diagnostic testing
-
AS/NZS IEC 60812:2020
Failure modes and effects analysis (FMEA and FMECA)
-
AS/NZS IEC 61123:2022
Reliability testing - Compliance test plans for success ratio
-
AS/NZS IEC 61649:2020
Weibull analysis
BS 2564:1955
Get this standard
Prices exclude GST
PDF
( Single user document)
$532.48 NZD
HardCopy
$523.48 NZD