ISO 8503-2:2012
Preparation of steel substrates before application of paints and related products — Surface roughness characteristics of blast-cleaned steel substrates — Part 2: Method for the grading of surface profile of abrasive blast-cleaned steel — Comparator proced
ISO 8503-2:2012 describes a visual and tactile method for assessing the grade of the profile which is produced by one of the abrasive blast-cleaning procedures described in ISO 8504‑2.
The method uses ISO surface profile comparators for assessing, on site, the roughness of surfaces before the application of paint or other protective treatments.
The method is applicable to steel surfaces which have been blast-cleaned by use of either shot abrasives or grit abrasives, but is only applicable to grades Sa 2½ and Sa 3 of ISO 8501‑1 where the entire surface under test shows an overall blast-cleaned appearance.
lt is applicable to surfaces which have been cleaned with either metallic or non-metallic abrasives.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$83.00 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Maintenance and re-calibration of comparators
7 Procedure
8 Test report
Previous versions
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
AS/NZS 4361.1:2017
Guide to hazardous paint management - Part 1: Lead and other hazardous metallic pigments in industrial applications -
AS/NZS 4361.2:2017
Guide to hazardous paint management - Part 2: Lead paint in residential, public and commercial buildings -
BS 7079:2009
General introduction to standards for preparation of steel substrates before application of paints and related products
-
BS EN 12921-1:2005+A1:2010
Machines for surface cleaning and pre-treatment of industrial items using liquids or vapours, Common safety requirements
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Maintenance and re-calibration of comparators
7 Procedure
8 Test report