ISO 13179-1:2014
Implants for surgery — Plasma-sprayed unalloyed titanium coatings on metallic surgical implants — Part 1: General requirements
ISO 13179-1:2014 specifies general requirements for plasma-sprayed unalloyed titanium coatings on metallic surgical implants. It applies to plasma spraying in air and in vacuum.
ISO 13179-1:2014 does not apply to coatings made of other materials than unalloyed titanium or coatings realized by another technology than plasma spraying.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$126.00 NZD
|
|
| Networkable PDF |
Price varies
|
Section sec_1
Section sec_2
Section sec_3
Section sec_3.1
Section sec_3.2
Section sec_4
Section sec_4.1
Section sec_4.2
Section sec_4.2.1
Table tab_1
Section sec_4.2.2
Section sec_4.2.3
Section sec_4.3
Section sec_4.4
Section sec_4.4.1
Section sec_4.4.2
Section sec_4.4.3
Section sec_4.4.4
Section sec_4.4.5
Section sec_4.5
Section sec_4.6
Section sec_5
Reference ref_1
Reference ref_2
Reference ref_3
Reference ref_4
Reference ref_5
Reference ref_6
Reference ref_7
Reference ref_8
Reference ref_9
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
4.1 Powder for plasma spraying
4.2 Chemical analysis
4.3 Morphology
4.4 Coating mechanical properties
4.5 Audit control
4.6 Significance of numerical limits
5 Test report
Bibliography
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
AS/NZS 2817:1997
Implants for surgery - Care and handling of orthopaedic implants
-
BS 2574-1:1991
Lower limb orthoses, Guide to the design and manufacture of lower limb orthoses, excluding foot orthoses
-
BS 2574-2:1994
Lower limb orthoses, Specification for hip, knee and ankle joints for lower limb orthoses
-
BS 3531-11:1991
Implants for osteosynthesis, Implants for osteosynthesis. Specification for staples with parallel legs
Section sec_1
Section sec_2
Section sec_3
Section sec_3.1
Section sec_3.2
Section sec_4
Section sec_4.1
Section sec_4.2
Section sec_4.2.1
Table tab_1
Section sec_4.2.2
Section sec_4.2.3
Section sec_4.3
Section sec_4.4
Section sec_4.4.1
Section sec_4.4.2
Section sec_4.4.3
Section sec_4.4.4
Section sec_4.4.5
Section sec_4.5
Section sec_4.6
Section sec_5
Reference ref_1
Reference ref_2
Reference ref_3
Reference ref_4
Reference ref_5
Reference ref_6
Reference ref_7
Reference ref_8
Reference ref_9
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
4.1 Powder for plasma spraying
4.2 Chemical analysis
4.3 Morphology
4.4 Coating mechanical properties
4.5 Audit control
4.6 Significance of numerical limits
5 Test report
Bibliography