ISO 11088:2015
Assembly, adjustment and inspection of an alpine ski/binding/boot (S-B-B) system
ISO 11088:2015 specifies assembly, adjustment and inspection procedures for the binding mechanisms of skis, integrating in a practical way, the requirements of those International Standards which are related to skis, bindings and boots.
It is intended for all individuals and institutions concerned with those procedures, and especially for sports retailers.
It is applicable to a ski/binding/boot system (S-B-B) for alpine skiing, of which at least one component is owned by the user.
NOTE In the case where the two components (SB and B) are rented, ISO 13993 gives a method of measurement by sampling as an alternative to systematic measurement, before delivery to the end-user.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$141.75 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Skier’s parameters
4.1 General
4.2 Weight method
5 Equipment parameters
5.1 Choice of new equipment
5.2 Visual inspection and preparation of used equipment
5.3 Assembly
5.4 Binding-to-boot fitting adjustments
5.5 Initial indicator adjustment
5.6 Functional check (inspection of functions)
5.7 Measurement of release moment
5.8 Report
Annex A (normative) Definition of skier type
Annex B (normative) Method of setting
Annex C (normative) Flow chart
Annex D (normative) Clean versus lubricated diagnostic test for boot/binding compatibility
Annex E (normative) Drill
Bibliography
Previous versions
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
BS EN 1077:2007
Helmets for alpine skiers and snowboarders
-
BS EN 13178:2000
Personal eye protection. Eye protectors for snowmobile users
-
BS EN 13484:2012
Helmets for users of luges
-
BS EN 13781:2012
Protective helmets for drivers and passengers of snowmobiles and bobsleighs
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Skier’s parameters
4.1 General
4.2 Weight method
5 Equipment parameters
5.1 Choice of new equipment
5.2 Visual inspection and preparation of used equipment
5.3 Assembly
5.4 Binding-to-boot fitting adjustments
5.5 Initial indicator adjustment
5.6 Functional check (inspection of functions)
5.7 Measurement of release moment
5.8 Report
Annex A (normative) Definition of skier type
Annex B (normative) Method of setting
Annex C (normative) Flow chart
Annex D (normative) Clean versus lubricated diagnostic test for boot/binding compatibility
Annex E (normative) Drill
Bibliography