BS 3821-2:1974
Specification for hardmetal dies and associated hardmetal tools, As-sintered pellets and finished dies for drawing round wire
Shows the dimensions of as-sintered pellets and finished hardmetal dies and certain quality aspects of finished dies for drawing ferrous and non-ferrous round wire. The dies are intended to produce wire up to 12 mm diameter from steel and 13 mm diameter from non-ferrous material.
Related Information
Similar Standards
-
BS 3821-1:1974
Specification for hardmetal dies and associated hardmetal tools, Designation and marking of as-sintered pellets and finished dies
-
BS 3821-3:1974
Specification for hardmetal dies and associated hardmetal tools, As-sintered pellets and finished dies for drawing round bar
-
BS 3821-4:1982
Specification for hardmetal dies and associated hardmetal tools, Dimensions and tolerances of as-sintered hardmetal pellets used in heading dies
-
BS EN 15949:2012
Safety of machinery. Safety requirements for bar mills, structural steel mills and wire rod mills