ISO/TS 19278:2019
Plastics — Instrumented micro-indentation test for hardness measurement
This document specifies a hardness test method for plastics using instrumented indentation in the micro scale with one clearly defined test condition to ensure reproducibility and comparability of test results.
The test method is selectively suitable for use with the following materials:
— moulding, extrusion and cast thermoplastic materials; rigid and semi-rigid thermoplastics sheets;
— rigid and semi-rigid thermosetting moulding materials; thermosetting sheets.
This test method could also be utilized for nanometric filled system, considering the fillers are distributed uniformly in the polymer matrix.
This test method allows dumbbell type specimen, strip type specimen, platens and specimen cut from any finished parts or products.
This test method is useful for quality control, material selection, and screening of new formulations.
NOTE This document does not aim to describe all scientific or technical aspects of microhardness testing on plastics in general.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| Networkable PDF |
Price varies
|
Keep me up-to-date
Register to receive notifications when updates are made to this standard.
Related Information
Similar Standards
-
BS 2782-0:2011
Methods of testing plastic, Introduction
-
BS 2782-1:Method 140A:1992
Methods of testing plastics. Thermal properties, Determination of the burning behaviour of horizontal and vertical specimens in contact with a small-flame ignition source
-
BS 2782-1:Method 140E:1982
Methods of testing plastics. Thermal properties, Flammability of a small, inclined test piece exposed to an alcohol flame (laboratory method)
-
BS 2782-1:Method 150D:1976
Methods of testing plastics. Thermal properties, Cold crack temperature of film and thin sheeting