ISO 8099-1:2018
Small craft — Waste systems — Part 1: Waste water retention
ISO 8099-1:2018 specifies requirements for the design, construction and installation of systems for temporary retention of sewage for subsequent disposal. It applies to small craft with a length of hull (LH) of up to 24 m.
ISO 8099-1:2018 does not address waste water treatment systems.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$126.00 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
1 Scope
2 Normative reference
3 Terms and definitions
4 General requirements
5 Materials
6 Plumbing system
6.1 Hoses and piping
6.2 Seacock fitting
7 Vent system
7.1 Venting of gases
7.1.1 Heel angles
7.1.2 Inside diameter of fittings
7.1.3 Prevention of clogging — Pressure resistance
7.1.4 Flow area
7.2 Venting of tanks
7.2.1 Rigid tanks with capacity of less than 400 l
7.2.2 Rigid tanks with capacity of 400 l and greater
7.2.3 Venting of flexible tanks
8 Holding tanks
8.1 General requirements
8.1.1 Fastening
8.1.2 Indication of contents level
8.1.3 Accessibility of fittings and connections
8.1.4 Access opening
8.1.5 Tank walls
8.2 Requirements for permanently installed holding tanks
8.3 Requirements for portable holding tanks
9 Pump-out fitting
10 Identification
11 Information for owner's manual
Annex A (normative) Nominal design of pump-out fitting
Annex B (informative) Typical installations for toilet retention systems
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
BS 7161:1990
Specification for propeller shaft ends and bosses for inboard-engined pleasure craft
-
BS 7852:1997
Code of practice for design of canoes and kayaks
-
BS EN 14144:2003
Lifebuoys. Requirements, tests
-
BS EN 14145:2003
Holders for lifebuoys
Foreword
1 Scope
2 Normative reference
3 Terms and definitions
4 General requirements
5 Materials
6 Plumbing system
6.1 Hoses and piping
6.2 Seacock fitting
7 Vent system
7.1 Venting of gases
7.1.1 Heel angles
7.1.2 Inside diameter of fittings
7.1.3 Prevention of clogging — Pressure resistance
7.1.4 Flow area
7.2 Venting of tanks
7.2.1 Rigid tanks with capacity of less than 400 l
7.2.2 Rigid tanks with capacity of 400 l and greater
7.2.3 Venting of flexible tanks
8 Holding tanks
8.1 General requirements
8.1.1 Fastening
8.1.2 Indication of contents level
8.1.3 Accessibility of fittings and connections
8.1.4 Access opening
8.1.5 Tank walls
8.2 Requirements for permanently installed holding tanks
8.3 Requirements for portable holding tanks
9 Pump-out fitting
10 Identification
11 Information for owner's manual
Annex A (normative) Nominal design of pump-out fitting
Annex B (informative) Typical installations for toilet retention systems