ISO 6413:2018
Technical product documentation — Representation of splines and serrations
This document specifies the rules and graphical symbols for the representations of splines and serrations in technical product documentation.
Two methods of representation are specified:
a) complete representation;
b) simplified representation.
The rules and graphical symbols specified in this document are applicable to detail drawings of parts (shafts and hubs) and to assembly drawings of joints.
NOTE For uniformity, all the figures in this document have been drawn in the first-angle orthographic projection. A third-angle orthographic projection could equally have been used without prejudice to principles established.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
4.1 Graphical symbols
4.2 Method for indication designation
5 Complete representation of spline joints
6 Simplified representation
6.1 General
6.2 Representation of details (shafts and hubs)
6.2.1 General
6.2.2 Contours and edges
6.2.3 Root surface
6.2.4 Pitch surface
6.2.5 Usable length
6.2.6 Tool run-out
6.2.7 Position of teeth
6.2.8 Detailed drawing of tooth profile
6.2.9 Flanks
7 Assembly drawings
Annex A (normative) Proportions and dimensions of graphical symbols
Bibliography
Previous versions
Keep me up-to-date
Register to receive notifications when updates are made to this standard.
Related Information
Similar Standards
-
AS/NZS 1100.501:2002
Technical drawing - Structural engineering drawing
-
BS 2059:1953
Specification for straight-sided splines and serrations
-
BS 2059/1:1957 - SET
Summary sheet: straight sided splines. Bottom fitting. Shallow
-
BS 2059/2:1957 - SET
Summary sheet: straight sided splines. Bottom fitting. Deep
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
4.1 Graphical symbols
4.2 Method for indication designation
5 Complete representation of spline joints
6 Simplified representation
6.1 General
6.2 Representation of details (shafts and hubs)
6.2.1 General
6.2.2 Contours and edges
6.2.3 Root surface
6.2.4 Pitch surface
6.2.5 Usable length
6.2.6 Tool run-out
6.2.7 Position of teeth
6.2.8 Detailed drawing of tooth profile
6.2.9 Flanks
7 Assembly drawings
Annex A (normative) Proportions and dimensions of graphical symbols
Bibliography