ISO 6117:2005
Road vehicles — Elastomeric boots for drum-type, hydraulic brake wheel cylinders using a non-petroleum base hydraulic brake fluid (service temperature 100 degrees C max.)
ISO 6117:2005 specifies performance tests for moulded rubber boots used at end closures on drum type wheel brake cylinders; these boots prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation.
It is applicable to boots of both plain and reinforcement insert types, for fitting in wheel cylinders using a fluid in accordance with ISO 4925. It does not include requirements relating to chemical composition, tensile strength or elongation at brake of the rubber compound; it dose not cover the strength of adhesion of rubber to the reinforcement in the insert type.
The rubber material used in these boots is suitable for operation in a temperature range of -40 °C to +100 °C.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| Networkable PDF |
Price varies
|
Keep me up-to-date
Register to receive notifications when updates are made to this standard.
Related Information
Similar Standards
-
BS 5409-1:1976
Specification for nylon tubing, Fully plasticized nylon tubing types 11 and 12 for use primarily in pneumatic installations
-
BS AU 110a:1995
Specification for rubber hoses and hose assemblies for automotive air pressure braking systems
-
BS AU 163a:1985
Specification for pressure test connection for compressed-air pneumatic braking equipment for road vehicles
-
BS AU 180-2:1982
Brake linings, Method for measurement of internal shear strength of lining material