ISO 21712:2020
Fine ceramics (advanced ceramics, advanced technical ceramics) — Test method for flexural bond strength of ceramics
This document specifies a test method for determining the flexural bond strength of ceramic/ceramic joints or ceramic/metal joints at room temperature. The substrate materials, for example ceramic or metal, are both monolithic. This method can be used to test the interfacial bond strength of the joint under bending conditions. It can be used for the development of joining materials and/or for the quality control of joints, the characterization and generating design data purposes.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| HardCopy |
$152.17 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
5.1 Testing machine
5.2 Test fixture
5.2.1 General
5.2.2 Bearings
5.2.3 Positioning of bearings
5.2.4 Fixture material
5.3 Micrometer
6 Test specimens
6.1 Specimen size
6.1.1 Type A specimens
6.1.2 Type B specimens
6.1.3 Chamfering and rounded edge
6.2 Specimen preparation
6.2.1 General
6.2.2 Custom machining procedure
6.2.3 Component-matched procedure
6.2.4 Basic machining procedure
6.2.5 Parallelism, orthogonality and chamfer sizes
6.2.6 Handling of specimens
6.2.7 Number of specimens
7 Procedure
8 Calculation
9 Test report
Keep me up-to-date
Register to receive notifications when updates are made to this standard.
Related Information
Similar Standards
-
BS 7134-0:1989
Testing of engineering ceramics, Introduction and guide to sampling
-
BS EN 1006:2009
Advanced technical ceramics. Monolithic ceramics. Guidance on the selection of test pieces for the evaluation of properties
-
BS EN 1007-1:2002
Advanced technical ceramics. Ceramic composites. Methods of test for reinforcements, Determination of size content
-
BS EN 1007-2:2002
Advanced technical ceramics. Ceramic composites. Methods of test for reinforcements, Determination of linear density
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
5.1 Testing machine
5.2 Test fixture
5.2.1 General
5.2.2 Bearings
5.2.3 Positioning of bearings
5.2.4 Fixture material
5.3 Micrometer
6 Test specimens
6.1 Specimen size
6.1.1 Type A specimens
6.1.2 Type B specimens
6.1.3 Chamfering and rounded edge
6.2 Specimen preparation
6.2.1 General
6.2.2 Custom machining procedure
6.2.3 Component-matched procedure
6.2.4 Basic machining procedure
6.2.5 Parallelism, orthogonality and chamfer sizes
6.2.6 Handling of specimens
6.2.7 Number of specimens
7 Procedure
8 Calculation
9 Test report