Plastics — Methods for marine exposure
ISO 15314:2004 describes three methods for the exposure of plastics in a marine environment. Method A covers exposures where specimens float on the surface, method B covers exposures where specimens are partially immersed and method C covers exposures where specimens are completely immersed. Although intended for marine (salt water) exposure, the methodology might be used with outdoor brackish water and fresh-water exposures as well.
Method A is particularly applicable to enhanced-degradability plastics where the environmental degradation under marine floating exposure is expected to be accelerated relative to that of regular plastic materials.
The standard specifies the general requirements for the apparatus, and procedures for using the test methods described.
It lists properties that may be used to evaluate changes in plastics subjected to marine exposure. More specific information about methods for determining the changes in properties of plastics on exposure and reporting these results is given in ISO 4582, Plastics -- Determination of changes in colour and variations in properties after exposure to daylight under glass, natural weathering or laboratory light sources.
|Get this standard||Prices exclude GST|
|PDF ( Single user document)||
Keep me up-to-dateSign up to receive updates when there are changes to this standard
Methods of testing plastic, Introduction
BS 2782-1:Method 140A:1992
Methods of testing plastics. Thermal properties, Determination of the burning behaviour of horizontal and vertical specimens in contact with a small-flame ignition source
BS 2782-1:Method 140E:1982
Methods of testing plastics. Thermal properties, Flammability of a small, inclined test piece exposed to an alcohol flame (laboratory method)
BS 2782-1:Method 150D:1976
Methods of testing plastics. Thermal properties, Cold crack temperature of film and thin sheeting