ISO 11403-1:2021
Plastics — Acquisition and presentation of comparable multipoint data — Part 1: Mechanical properties
This document specifies test procedures for the acquisition and presentation of multipoint data on the following mechanical properties of plastics:
— dynamic modulus;
— tensile properties at constant test speed;
— ultimate stress and strain;
— tensile stress-strain curves;
— tensile creep;
— Charpy impact strength;
— puncture impact behaviour.
The test methods and test conditions apply predominantly to those plastics that can be injection- or compression-moulded or prepared as sheets of specified thickness from which specimens of the appropriate size can be machined.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| HardCopy |
$152.17 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Specimen preparation
5 Conditioning
6 Test requirements
6.1 General
6.2 Dynamic modulus
6.3 Tensile properties at constant test speed
6.3.1 General
6.3.2 Ultimate stress and strain
6.3.3 Tensile stress-strain curves
6.4 Tensile creep
6.5 Charpy impact strength
6.6 Puncture impact behaviour
7 Presentation of data
8 Precision
Bibliography
Previous versions
Keep me up-to-date
Register to receive notifications when updates are made to this standard.
Related Information
Similar Standards
-
BS 2782-0:2011
Methods of testing plastic, Introduction
-
BS 2782-1:Method 140A:1992
Methods of testing plastics. Thermal properties, Determination of the burning behaviour of horizontal and vertical specimens in contact with a small-flame ignition source
-
BS 2782-1:Method 140E:1982
Methods of testing plastics. Thermal properties, Flammability of a small, inclined test piece exposed to an alcohol flame (laboratory method)
-
BS 2782-1:Method 150D:1976
Methods of testing plastics. Thermal properties, Cold crack temperature of film and thin sheeting
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Specimen preparation
5 Conditioning
6 Test requirements
6.1 General
6.2 Dynamic modulus
6.3 Tensile properties at constant test speed
6.3.1 General
6.3.2 Ultimate stress and strain
6.3.3 Tensile stress-strain curves
6.4 Tensile creep
6.5 Charpy impact strength
6.6 Puncture impact behaviour
7 Presentation of data
8 Precision
Bibliography