BS ISO 10816-3:2009+A1:2017
Mechanical vibration. Evaluation of machine vibration by measurements on non-rotating parts, Industrial machines with nominal power above 15 kW and nominal speeds between 120 r/min and 15 000 r/min when measured in situ
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$326.00 NZD
|
|
| HardCopy |
$379.00 NZD
|
|
National foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Measurement procedures and operational conditions
3.1 General
3.2 Measurement equipment
3.3 Measurement locations
3.4 Continuous and non-continuous monitoring
3.5 Operational conditions
4 Machine classification
4.1 General
4.2 Classification according to machine type, rated power or shaft height
4.3 Classification according to support flexibility
5 Evaluation
5.1 General
5.2 Criterion I: Vibration magnitude
5.2.1 General
5.2.2 Evaluation zones
5.2.3 Evaluation zone limits
5.2.4 Axial vibration
5.3 Criterion II: Change in vibration magnitude
5.4 Operational limits
5.4.1 Setting of ALARMS
5.4.2 Setting of TRIPS
5.5 Supplementary procedures/criteria
5.6 Evaluation based on vibration vector information
Annex A (normative) Evaluation zone boundaries
Bibliography
Previous versions
Related Information
Similar Standards
-
AS/NZS 4024.2804:2021
Safety of machinery, Part 2804: Safety-related sensors used for the protection of persons
-
AS/NZS IEC 60300.1:2025
Dependability management – Part 1: Managing dependability
-
AS/NZS IEC 60706.3:2022
Maintainability of equipment - Part 3: Verification and collection, analysis and presentation of data
-
AS/NZS IEC 60706.5:2022
Maintainability of equipment, Part 5: Testability and diagnostic testing
National foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Measurement procedures and operational conditions
3.1 General
3.2 Measurement equipment
3.3 Measurement locations
3.4 Continuous and non-continuous monitoring
3.5 Operational conditions
4 Machine classification
4.1 General
4.2 Classification according to machine type, rated power or shaft height
4.3 Classification according to support flexibility
5 Evaluation
5.1 General
5.2 Criterion I: Vibration magnitude
5.2.1 General
5.2.2 Evaluation zones
5.2.3 Evaluation zone limits
5.2.4 Axial vibration
5.3 Criterion II: Change in vibration magnitude
5.4 Operational limits
5.4.1 Setting of ALARMS
5.4.2 Setting of TRIPS
5.5 Supplementary procedures/criteria
5.6 Evaluation based on vibration vector information
Annex A (normative) Evaluation zone boundaries
Bibliography