BS 4500-4:1985
Withdrawn
Date published:
ISO limits and fits, Specification for system of cone (taper) fits for cones from <i>C</i>=1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm
Applies to cones which are dimensioned and toleranced according to method 1 (basic taper method) of ISO 3040. Specifies a hole basis system of fits.
Related Information
17.040.10 Limits and fits
Similar Standards
-
BS 1916-1:2009
Limits and fits for engineering, Guide to limits and tolerances
-
BS 1916-2:2009
Limits and fits for engineering, Guide to the selection of fits in BS 1916-1
-
BS 1916-3:2009
Limits and fits for engineering, Guide to tolerances, limits and fits for large diameters
-
BS 2856:1973
Precise conversion of inch and metric sizes on engineering drawings