BS 1916-1:1953
Limits and fits for engineering, Limits and tolerances
Tables of fundamental tolerances in sixteen grades and of limits for twenty-one qualities of shafts and holes in inch and metric. Metric tables extracted from ISA system, inch tables are direct conversion with values rounded in accordance with a preferred series of tolerances. Explanation of system, diagrams, disposition of tolerance zones for holes and shafts, selection of fits for general engineering. Formulae from which fits are derived. Imperial units only.
Related Information
Similar Standards
-
BS 1916-1:2009
Limits and fits for engineering, Guide to limits and tolerances
-
BS 1916-2:2009
Limits and fits for engineering, Guide to the selection of fits in BS 1916-1
-
BS 1916-3:2009
Limits and fits for engineering, Guide to tolerances, limits and fits for large diameters
-
BS 2856:1973
Precise conversion of inch and metric sizes on engineering drawings