Plastics — Determination of resistance to wear by abrasive wheels
1.1 This International Standard specifies a general method for determining the resistance to abrasive wear of plastics under the action of abrasive wheels. It is equally applicable to moulded test specimens, components
and finished products.
1.2 The particular test conditions and the method of expressing the results may differ according to the type of material. The test conditions and specific method are specified in the relevant standards for each material or product.
This method is not applicable to cellular materials or paints.
|Get this standard||Prices exclude GST|
|PDF ( Single user document)||
Keep me up-to-dateSign up to receive updates when there are changes to this standard
Methods of testing plastic, Introduction
BS 2782-1:Method 140A:1992
Methods of testing plastics. Thermal properties, Determination of the burning behaviour of horizontal and vertical specimens in contact with a small-flame ignition source
BS 2782-1:Method 140E:1982
Methods of testing plastics. Thermal properties, Flammability of a small, inclined test piece exposed to an alcohol flame (laboratory method)
BS 2782-1:Method 150D:1976
Methods of testing plastics. Thermal properties, Cold crack temperature of film and thin sheeting