Wrought aluminium and aluminium alloys — Cold-drawn rods/bars, tubes and wires — Part 5: Tolerances on form and dimensions for drawn square and hexagonal bars and wires
This document specifies the tolerances on form and dimensions of wrought aluminium and aluminium alloy drawn square and hexagonal bars and wires with widths across flats up to and including 100 mm.
For wires, this document does not apply to electrical, welding and aeronautical purposes.
For drawn bars, 4.1 to 4.5 apply, and only 4.1 applies to drawn wires.
|Get this standard||Prices exclude GST|
|PDF ( Single user document)||
Keep me up-to-dateSign up to receive updates when there are changes to this standard
Specification for aluminium alloy sections for structural purposes
Specification for wrought aluminium and aluminium alloys for general engineering purposes - rivet, bolt and screw stock
Specification for wrought aluminium for electrical purposes. Strip with drawn or rolled edges
Specification for wrought aluminium for electrical purposes. Solid conductors for insulated cables