ISO 14900:2017
Plastics — Polyols for use in the production of polyurethane — Determination of hydroxyl number
ISO 14900:2017 specifies two methods for the measurement of the hydroxyl number of polyols used as polyurethane raw materials. It is necessary to know the hydroxyl content of polyols to properly formulate polyurethane systems. Method A is primarily applicable to readily esterified polyether polyols. It is also intended for polyols which have significant steric hindrance, such as those based on sugars. Method B is intended for polyether polyols, polymer polyols and amine-initiated polyols, but may give low results for sterically hindered polyols. Other polyols can be analysed by these methods if precautions are taken to verify applicability. These methods can be used for research and for quality control and specification purposes.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| HardCopy |
$152.17 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Interferences
6 Reagents
7 Apparatus
8 Method A — Acetylation
8.1 Procedure
8.2 Expression of results
8.3 Precision and bias
8.4 Test report
9 Method B — Phthalation
9.1 Procedure
9.2 Expression of results
9.3 Precision and bias
9.4 Test report
Bibliography
Previous versions
Keep me up-to-date
Register to receive notifications when updates are made to this standard.
Related Information
Similar Standards
-
BS 1322:1992
Specification for aminoplastic moulding materials
-
BS 2782-1:Methods 131C and 131D:1978
Methods of testing plastics. Thermal properties, Crushing strength after heating (heat resistance) of thermosetting moulding material. Crushing strength after heating (heat resistance) of thermosetting laminated sheet or mouldings
-
BS 2782-4:Method 433A:1979
Methods of testing plastics. Chemical properties, Determination of inorganic chlorine in epoxide resins and glycidyl esters
-
BS 2782-4:Method 451A:1978
Methods of testing plastics. Chemical properties, Determination of acetone-soluble matter in phenolic mouldings
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Interferences
6 Reagents
7 Apparatus
8 Method A — Acetylation
8.1 Procedure
8.2 Expression of results
8.3 Precision and bias
8.4 Test report
9 Method B — Phthalation
9.1 Procedure
9.2 Expression of results
9.3 Precision and bias
9.4 Test report
Bibliography