Skip to main content

BS 5600-3-3.7:1979

Date published:

Powder metallurgical materials and products. Methods of testing sintered metal materials and products, excluding hardmetals, Tensile test pieces

NOTE: The hard copy of this product is purchased from overseas and will take longer than usual to deliver

Specifies the die cavity dimensions used for making tensile test pieces by pressing and sintering, together with certain dimensions of the test piece obtained from such a die, and the dimensions of tensile test pieces machined from sintered materials.

Get this standard Prices exclude GST
HardCopy
$395.60 NZD
Preview only close
Prev {{ page }}/ {{ numPages }} Next
Preview only close
Prev {{ page }}/ {{ numPages }} Next
Pages: 0

Related Information

Similar Standards

  • BS 2955:1993

    Glossary of terms relating to particle technology

  • BS 4276:1968

    Specification for hard metal for wire, bar and tube drawing dies

  • BS 4359-4:1995

    Determination of the specific surface area of powders, Recommendations for methods of determination of metal surface area using gas adsorption techniques

  • BS 5600-1.1:1979

    Powder metallurgical materials and products. General information, Introduction and contents

Preview only close
Prev {{ page }}/ {{ numPages }} Next
Preview only close
Prev {{ page }}/ {{ numPages }} Next
Pages: 0

BS 5600-3-3.7:1979

Get this standard Prices exclude GST
HardCopy
$395.60 NZD

Request to add this standard to your subscription

BS 5600-3-3.7:1979

Price varies
Online library subscription

Click "Send request for subscription" to ask your Account Administrator to add this standard to your subscripiton.

Cancel