close

Tell your friends about this article!

Friend's email address:
  For example, username@domain.com
Your email address:
  For example, username@domain.com
Subject:
Message:
Send the email
This message has been sent to you from Touchstone, Standards New Zealand's free electronic magazine. Standards New Zealand is the country's leading Standards body, developing and promoting Standards for the benefit of all New Zealanders.

When the message is sent, you'll automatically be copied on the message. The text immediately above will be added to the message automatically, identifying the message as coming from Touchstone.

close

Thanks

Your email has been sent
Title BannerTitle BannerTitle BannerTitle BannerTitle Banner

Touchstone

ISSN 1179-2426

Engineering

NEW PUBLICATIONS

NZS 3404 Steel structures Standard

NZS 3404.1:2009 Steel structures Standard – Materials, fabrication, and construction (Looseleaf and binder)

NZS 3404.1 sets out minimum requirements for the selection of materials, corrosion protection systems, and the fabrication, erection, and construction of steel structures. It will supersede the relevant provisions in NZS 3404:1997 and will be referenced by NZS 3404.2 to NZS 3404.7 once those parts are complete. This Standard applies to building structures; crane support girders; highway, railway and pedestrian bridges; and composite steel and concrete beams and columns. This Standard is supplied with loose pages in a ring binder.

→ Buy this Standard

NZS 3404.1:2009 Steel structures Standard – Materials, fabrication, and construction (Looseleaf pages)

NZS 3404.1 sets out minimum requirements for the selection of materials, corrosion protection systems, and the fabrication, erection, and construction of steel structures. It will supersede the relevant provisions in NZS 3404:1997 and will be referenced by NZS 3404.2 to NZS 3404.7 once those parts are complete. This Standard applies to building structures; crane support girders; highway, railway and pedestrian bridges; and composite steel and concrete beams and columns. This Standard is supplied with loose pages with 4 holes punched, suitable for a ring binder with 4 rings.

→ Buy this Standard

 
Back to top